How to Replace a Solenoid on a Sprinkler

May 10, 2010 Views

When a single sprinkler will not work, it can be confusing determining what is wrong. But in most home systems, when a single sprinkler will not work it is because the solenoid on that sprinkler is bad. The process for fixing this is as simple as putting gas in a car.

...

Read MoreSolenoidsolenoid  Sprinkler  

How Do Nitrous Solenoids Work?

May 10, 2010 Views

Introduction

  • Nitrous oxide is an accelerant much like an oxy acetylene torch. When the acetylene gas is turned on and ignited, it burns cool and with excessive smoke. Add oxygen to the acetylene, and all of a sudden, the flame jumps to in excess of 1800 degrees. Nitrous oxide accelerates fuel in much the same manner. It acts somewhat like a supercharger in as much as it allows much more air and fuel to ignite in the cylinders, creating tremendous pressure. Nitrous oxide and fuel are injected into the cylinders in a balanced mixture that keeps the additional heat at an acceptable limit....

How to Replace a Sprinkler Solenoid

May 10, 2010 Views

Most home sprinkler systems have control solenoids on the control valves for each zone. However, there are some systems that are large enough to have a control solenoid on each sprinkler head, like the systems used on golf courses. The easiest way to determine where the control solenoids are is to look at how the system works. If a large number of heads all come on at the same time, then the system is a zone system with control valves. If the system has the ability to turn on one head at a time and there are more wires than a normal person can keep track of coming into the controller, then the system has solenoids on each head. Replacing the solenoids is the same for both system types.

...

How to Replace the Starter in a Jeep Grand Cherokee

May 10, 2010 Views

A starter cranks the 3.7L or 4.7L engine, drawing air and fuel into the cylinders of your Jeep Grand Cherokee and compressing them so they will ignite. It also gets the ignition and crankshaft into place so the spark plugs will fire and the fuel injectors will operate. Therefore, a failing starter will prevent the engine from starting. Follow these steps to replace the starter in a 1999 to 2005 Jeep Grand Cherokee.

...

Read MoreSolenoid valve

How to Locate a Irrigation Solenoid Valve

May 10, 2010 Views

Most home irrigation systems have the control valves installed in ground boxes or above ground. But, in some situations the valves are buried directly in the ground without a box. In this case, locating the valve can be a hit or miss operation without the correct tool. While it is possible to locate a valve with a simple metal detector, most valves do not have enough metal to register on the detector. The easiest way to locate the valve is to trace the wire.

...

Read MoreSolenoid valveSolenoid valve  

How to Test a 12 Volt Electric Solenoid

May 10, 2010 Views

When a solenoid no longer functions, the starter will not get any power to engage the flywheel and start the engine. In most cases there will be a clicking noise coming from inside of the solenoid as the magnetic switch attempts to close and complete the circuit. However, a drained battery or faulty wiring will also cause the same symptoms. Checking the voltage at the solenoid is a sure way to troubleshoot the problem.

...

Read MoreSolenoid Applied Volt Electric Solenoid  

How to Test a Water Valve Solenoid on a Whirlpool Icemaker

May 10, 2010 Views

The water valve solenoid is the part which directs water from your house's water supply to the icemaker inside your Whirlpool refrigerator. Sometimes a solenoid can go bad, resulting in no water reaching your icemaker. Even if the solenoid is feeding water, it may be feeding too slow or dripping water slowly into the icemaker when it shouldn't be. This can cause the water line to freeze. Learn how to test your solenoid to see if it may be the problem.

...

Read MoreSolenoid Applied Water Valve Solenoid  

How to Put a New Boat Starter Solenoid in a MerCruiser

May 10, 2010 Views

You turn the key on the dashboard of your boat and nothing happens. With the key in the "Run" position, the gauges on the dash activate, the audible low oil-pressure warning sounds, but the starter on the engine fails to activate and start the motor. Since the gauges work, chances are the starting battery is charged. Since the starter doesn't engage and even slowly try to start the motor, chances are the battery isn't just low on energy. You probably need to replace one of the two starter solenoids present on MerCruiser engines.

...

Troubleshooting Remote Car Starters

May 10, 2010 Views

Check your battery power

  • Car starters require access to the battery to start the engine. The easiest way to check the battery power of the car is to turn the lights on while the car is off. If the lights come on, your battery has power. Take a voltimeter (available at auto parts stores) and connect the leads to your battery. A fully charged battery has 12.5 volts. A dead battery has less than 11.8 volts....

Read MoreSolenoid Applied

What is a Solenoid Valve?

November 26, 2009 Views

A solenoid is an electromechanical device which allows for an electrical device to control the flow of a gas or liquid. The electrical device causes a current to flow through a coil located on the solenoid valve. This current flow in turn results in a magnetic field which causes the displacement of a metal actuator.

...

Read MoreSolenoid valveSolenoid valve  

Page:[«][1]2[3][4][5][»]